PEMKO
277. CSI 3-Part Specifications.
277AR SPEC 277 Rev May 1995
SPECIFIER NOTE:
THE FOLLOWING DATA IS INTENDED TO ASSIST IN SPECIFYING PEMKO
PRODUCTS. INCORPORATE IN A PROJECT SPECIFICATION WHERE
APPROPRIATE.
CAREFULLY REVIEW TO ENSURE COORDINATION WITH ALL CONTRACT
DOCUMENTS.
1. PRODUCT: Panic Exit Saddle (1/2"x 7/8"x 5"), Pemko #277AR
2. MANUFACTURER:
PEMKO * Ventura PEMKO * Memphis
4226 Transport Street 5535 Distribution Drive
Ventura, CA 93003 Memphis, TN 38141
Phone: (800) 283-9988 Phone (800) 824-3018
Fax: (800) 283-4050 Fax: (800) 243-3656
3. MATERIAL & FINISH:
SPECIFIER NOTE:
PRODUCT SELECTED IS AVAILABLE IN MATERIALS & FINISHES SPECIFIED
BELOW. WHERE MORE THAN ONE MATERIAL IS LISTED FOR A PRODUCT,
SELECT PARAGRAPH FOR MATERIAL YOU WANT.
EDIT BRACKETED TEXT TO SPECIFY FINISH. DELETE TEXT NOT DESIRED.
MATERIALS & FINISHES NOT LISTED MAY BE AVAILABLE BY SPECIAL
ORDER.
THRESHOLD:
Aluminum, Extruded
* Alloy Type 6063-T5
* Chemical and physical properties per the Aluminum
Association, Inc.
* Federal Specification QQ-A-200/9C
* [277AR Mill finish, 277DR Dark bronze anodized,
277GR Gold anodized].
SEAL:
Neoprene, Expanded, Closed Cell
* ASTM D1056-85 Type 2C2
* Mil-R6130C Type II Grade C
* -67 F. to +170 F.
4. TEST & CODE COMPLIANCE:
Fire Label: Classified By UL For Application To Swinging
Type Fire Doors of the Hollow Metal or Steel
Covered composite type Rated up to 3 Hours, or
Wood Core Fire Doors rated up to 1-1/2 Hours.
Listed and Labeled as Gasketing Materials.
Tested in accordance with UL10B by
Underwriters Laboratory, Inc. .
Smoke Label: Smoke tested by WYLE Laboratories in accordance
with UL 1784-90; meets the requirements of NFPA
105-1992.
5. INSTALLATION:
Installation to be performed in strict accordance with
manufacturer's instructions furnished with product.
Carefully cope to fit within the frame opening. Trim
neoprene seal to 1/16" longer than trimmed threshold on each
end. Press against door to assure good seal, (do not over
tighten - installer should be able to slip business card between
seal and door).Fasten with flat head wood or machine screws provided
and appropriate anchors as required. Use a sealant or compound at all
edges and joints.
6. WARRANTY:
Guaranteed by manufacturer against defects in material or
workmanship for 3 years.