PEMKO
29310. CSI 3-Part Specifications.
9310CS SPEC 29310 Rev May 1995
SPECIFIER NOTE:
THE FOLLOWING DATA IS INTENDED TO ASSIST IN SPECIFYING PEMKO
PRODUCTS. INCORPORATE IN A PROJECT SPECIFICATION WHERE
APPROPRIATE.
CAREFULLY REVIEW TO ENSURE COORDINATION WITH ALL CONTRACT DOCUMENTS.
1. PRODUCT: Rigid Jamb Weatherstrip with Snap-on Cover and
Silicone Seal (13/32" X 1"), Pemko #29310CS
2. MANUFACTURER:
PEMKO * Ventura PEMKO * Memphis
4226 Transport Street 5535 Distribution Drive
Ventura, CA 93003 Memphis, TN 38141
Phone:(800) 283-9988 Phone (800) 824-3018
Fax: (800) 283-4050 Fax: (800) 243-3656
3. MATERIAL & FINISH:
SPECIFIER NOTE:
PRODUCT SELECTED IS AVAILABLE IN MATERIALS & FINISHES SPECIFIED
BELOW. WHERE MORE THAN ONE MATERIAL IS LISTED FOR A PRODUCT,
SELECT PARAGRAPH FOR MATERIAL YOU WANT.
EDIT BRACKETED TEXT TO SPECIFY FINISH. DELETE TEXT NOT DESIRED.
MATERIALS & FINISHES NOT LISTED MAY BE AVAILABLE BY SPECIAL
ORDER.
HOUSING:
Aluminum, Extruded
* Alloy Type 6063-T5
* Chemical and physical properties per the Aluminum
Association, Inc.
* Federal Specification QQ-A-200/9C
* [29310CS Clear anodized, 29310DS Dark bronze anodized,
29310GS Gold anodized].
SEAL:
Silicone Rubber, Extruded
* Federal Specification ZZ-R-755 Class 2A Grade 60 Type I & II
* -100 F. to +400 F.
4. TEST & CODE COMPLIANCE
Fire Label: Classified By UL For Application To Swinging
Type Fire Doors of the Hollow Metal or Steel
Covered composite type Rated up to 3 Hours, or
Wood Core Fire Doors rated up to 1-1/2 Hours.
Listed and Labeled as Gasketing Materials.
Tested in accordance with UL10B by Underwriters
Laboratory, Inc. .
Smoke Label: Smoke tested by WYLE Laboratories in accordance
with UL 1784-90; meets the requirements of NFPA
105.
5. INSTALLATION:
Installation to be performed in strict accordance with
manufacturer's instructions furnished with product.
. Trim and fasten base unit to header stop first, then trim and
attach to jambs, ensuring contact at threshold. Carefully
miter or cope at corners to ensure tight joints and
continuous seal. Install screws in center of slots. Press
lightly against door to assure good seal. Note: do not over
tighten - installer should be able to slip business card
between seal and door. After best seal attained, tighten
screws. Trim snap-on covers to suit and snap on to previously
installed header and jambs.
6. WARRANTY:
Guaranteed by manufacturer against defects in material or
workmanship for 3 years.