PEMKO
305. CSI 3-Part Specifications.
05CR SPEC 305 Rev May 1995
SPECIFIER NOTE:
THE FOLLOWING DATA IS INTENDED TO ASSIST IN SPECIFYING PEMKO
PRODUCTS. INCORPORATE IN A PROJECT SPECIFICATION WHERE
APPROPRIATE.
CAREFULLY REVIEW TO ENSURE COORDINATION WITH ALL CONTRACT
DOCUMENTS.
1. PRODUCT: Rigid Jamb Weatherstrip with Closed Cell Sponge
Neoprene Seal (3/16" X 1-1/8"), Pemko #305CR
2. MANUFACTURER:
PEMKO * Ventura PEMKO * Memphis
4226 Transport Street 5535 Distribution Drive
Ventura, CA 93003 Memphis, TN 38141
Phone:(800) 283-9988 Phone (800) 824-3018
Fax: (800) 283-4050 Fax: (800) 243-3656
3. MATERIAL & FINISH:
SPECIFIER NOTE:
PRODUCT SELECTED IS AVAILABLE IN MATERIALS & FINISHES SPECIFIED
BELOW. WHERE MORE THAN ONE MATERIAL IS LISTED FOR A PRODUCT,
SELECT PARAGRAPH FOR MATERIAL YOU WANT.
EDIT BRACKETED TEXT TO SPECIFY FINISH. DELETE TEXT NOT DESIRED.
MATERIALS & FINISHES NOT LISTED MAY BE AVAILABLE BY SPECIAL
ORDER.
HOUSING:
Aluminum, Extruded
* Alloy Type 6063-T5
* Chemical and physical properties per the Aluminum Assoc.,
Inc.
* Federal Specification QQ-A-200/9C
* [305CR Clear anodized, 305DR Dark bronze anodized,
305GR Gold anodized].
Architectural bronze (brass), Extruded
* CDA alloy 38500 (56.5% Copper, 2.75% Lead, 40.7% Zinc,
0.05% alum.)
* [305BR Mill finish, Oxidized & oil rubbed, Polished, Satin
brush]
SEAL:
Neoprene, Expanded, Closed Cell
* ASTM D1056-85 Type 2C2
* Mil-R6130C Type II Grade C
* -67 F. to +170 F.
4. TEST & CODE COMPLIANCE
Fire Label: Classified By UL For Application To Swinging
Type Fire Doors of the Hollow Metal or Steel
Covered composite type Rated up to 3 Hours, or
Wood Core Fire Doors rated up to 1-1/2 Hours.
Listed and Labeled as Gasketing Materials.
Tested in accordance with UL10B by Underwriters
Laboratory, Inc. .
Smoke Label: Smoke tested by WYLE Laboratories in accordance
with UL 1784-90; meets the requirements of NFPA
105.
5. INSTALLATION:
Installation to be performed in strict accordance with
manufacturer's instructions furnished with product.
Trim and fasten to header stop first, then trim and attach to
jambs, ensuring contact at threshold. Carefully miter or cope
at corners to ensure tight joints and continuous seal.
Install screws in center of slots. Press lightly against
door to assure good seal. Note: Do not over tighten -
installer should be able to slip business card between seal
and door. After best seal attained, tighten screws.
6. WARRANTY:
Guaranteed by manufacturer against defects in material or
workmanship for 3 years.