PEMKO
321SS. CSI 3-Part Specifications.
321SSN SPEC 321SS Rev May 1995
SPECIFIER NOTE:
THE FOLLOWING DATA IS INTENDED TO ASSIST IN SPECIFYING PEMKO
PRODUCTS. INCORPORATE IN A PROJECT SPECIFICATION WHERE
APPROPRIATE.
CAREFULLY REVIEW TO ENSURE COORDINATION WITH ALL CONTRACT
DOCUMENTS.
1. PRODUCT: Door Sweep, Stainless Steel with Neoprene Seal
(1-15/16" x 3/16") Pemko #321SSN
2. MANUFACTURER:
PEMKO * Ventura PEMKO * Memphis
4226 Transport Street 5535 Distribution Drive
Ventura, CA 93003 Memphis, TN 38141
Phone: (800) 283-9988 Phone (800) 824-3018
Fax: (800) 283-4050 Fax: (800) 243-3656
3. MATERIAL & FINISH:
SPECIFIER NOTE:
PRODUCT SELECTED IS AVAILABLE IN MATERIALS & FINISHES SPECIFIED
BELOW. WHERE MORE THAN ONE MATERIAL IS LISTED FOR A PRODUCT,
SELECT PARAGRAPH FOR MATERIAL YOU WANT.
EDIT BRACKETED TEXT TO SPECIFY FINISH. DELETE TEXT NOT DESIRED.
MATERIALS & FINISHES NOT LISTED MAY BE AVAILABLE BY SPECIAL
ORDER.
DOOR SWEEP:
Stainless Steel
* Type 430
* Roll formed
* [321SSN Bright finish].
SEAL:
Neoprene, Solid, Extruded
* ASTM D2000-90 M2BC 507
* Mil-R-6855 Class 2 Grade 40
* Mil-R-6855 Class 2 Grade 50
* -67 F to +170 F.
4. TEST & CODE COMPLIANCE:
Fire Label: Classified By UL For Application To Swinging
Type Fire Doors of the Hollow Metal or Steel
Covered composite type Rated up to 3 Hours,
or
Wood Core Fire Doors rated up to 1-1/2 Hours.
Listed and Labeled as Gasketing Materials.
Tested in accordance with UL10B by
Underwriters Laboratory, Inc. .
Smoke Label: Labeled as Gasketing for Smoke Control Doors.
Tested per NFPA 105 by Wyle Laboratories
5. INSTALLATION:
Installation to be performed in strict accordance with
manufacturer's instructions furnished with product.
Cut housing to door width. Trim neoprene seal to 1/16" longer than
the trimmed housing on each end. Locate at door bottom and insure
seal with threshold. Fasten with #6 x 5/8" sheet metal screws
provided. NOTE: Not recommended for in-swinging doors..
6. WARRANTY:
Guaranteed by manufacturer against defects in material or
workmanship for 3 years