ÃÛÌÒÓ°Ïñ

MODULAR RAMP SPECIFICATION, 3A, 1.5 TO 2 OFFSET WITH

3-1/2" TOP PLATE ASD006 Rev May 1995

SPECIFIER NOTE:

THE FOLLOWING DATA IS INTENDED TO ASSIST IN SPECIFYING PEMKO

PRODUCTS. INCORPORATE IN A PROJECT SPECIFICATION WHERE

APPROPRIATE.

CAREFULLY REVIEW TO ENSURE COORDINATION WITH ALL CONTRACT

DOCUMENTS.

1. PRODUCT: MODULAR RAMP THRESHOLD ASSEMBLIES, OFFSET APPLICATION

WITH 3-1/2" TOP PLATE (1-1/2" TO 2" OFFSETS)

2. MANUFACTURER:

PEMKO * Ventura PEMKO * Memphis

4226 Transport Street 5535 Distribution Drive

Ventura, CA 93003 Memphis, TN 38141

Phone: (800) 283-9988 Phone (800) 824-3018

Fax: (800) 283-4050 Fax: (800) 243-3656

3. MATERIAL & FINISH:

SPECIFIER NOTE:

PRODUCT SELECTED IS AVAILABLE IN MATERIALS & FINISHES SPECIFIED

BELOW. WHERE MORE THAN ONE MATERIAL IS LISTED FOR A PRODUCT,

SELECT PARAGRAPH FOR MATERIAL YOU WANT.

EDIT BRACKETED TEXT TO SPECIFY FINISH. DELETE TEXT NOT DESIRED.

MATERIALS & FINISHES NOT LISTED MAY BE AVAILABLE BY SPECIAL

ORDER.

RAMP COMPONENTS:

NOTE: PEMKO STRONGLY RECOMMENDS PemKote SKID RESISTANT SURFACE

FOR ALL MODULAR RAMP THRESHOLD ASSEMBLIES. THIS RUGGED ABRASIVE

FINISH IS EXTREMELY SKID AND CORROSION RESISTANT AND CARRIES A

10-YEAR GUARANTEE.

Aluminum, Extruded

* Alloy Type 6063-T5

* Chemical and physical properties per the Aluminum

Association, Inc.

* Federal Specification QQ-A-200/9C.

* [Mill Finish, A; PemKote . AK]

MITER RETURN "WINGS" and EXTENSIONS

Aluminum, Cast

* Alloy Type 6061-F

* Chemical and physical properties per the Aluminum

Association, Inc.

* Federal Specification QQ-A-367.

* [Mill Finish, A; PemKote , AK]

4.TEST & CODE COMPLIANCE:

Handicapped: Complies with CABO/ANSI A117.1-1992; ADA

1990;ADAAG 1991 Guidelines.

Fire Label: Classified By UL For Application To Swinging

Type Fire Doors of the Hollow Metal or Steel

Covered composite type Rated up to 3 Hours, or

Wood Core Fire Doors rated up to 1-1/2

Hours Listed and Labeled as Gasketing

Materials. Tested in accordance with UL10B

by Underwriters Laboratory, Inc. .

5.INSTALLATION:

Installation to be performed in strict accordance with

manufacturers instructions furnished with product.

Top Plate: Carefully cope to fit within frame opening.

Fasten with No. 10 stainless steel flat head screws

provided and appropriate anchors. Use sealant or

compound at all edges and joints.

Ramp Sections: Trim or cope if required. Fasten with No.

10 stainless steel flat head screws provided and

appropriate anchors. Use sealant or compound at all

joints.

Miter Return "Wings": Cut to length as required. Fasten

to ramp component with screws provided. Use sealant or

compound at all edges and joints.

6 WARRANTY:

Guaranteed by manufacturer against defects in material or

workmanship for three years.PemKote Skid-Resistant

surface is guaranteed for 10 years.