PEMKO
ASD030. CSI 3-Part Specifications.
INSTITUTIONAL SYSTEM 1 (CORRECTIONAL), SPECIFICATION
ASD030 Rev May 1995
SPECIFIER NOTE:
THE FOLLOWING DATA IS INTENDED TO ASSIST IN SPECIFYING PEMKO
PRODUCTS. INCORPORATE IN A PROJECT SPECIFICATION WHERE
APPROPRIATE.
CAREFULLY REVIEW TO ENSURE COORDINATION WITH ALL CONTRACT
DOCUMENTS.
1. PRODUCT: PEMKO INSTITUTIONAL SYSTEM No. 1 (CORRECTIONAL)
2. MANUFACTURER:
PEMKO * Ventura PEMKO * Memphis
4226 Transport Street 5535 Distribution Drive
Ventura, CA 93003 Memphis, TN 38141
Phone:(800) 283-9988 Phone (800) 824-3018
Fax: (800) 283-4050 Fax: (800) 243-3656
3. MATERIAL & FINISH:
SPECIFIER NOTE:
PRODUCT SELECTED IS AVAILABLE IN MATERIALS & FINISHES SPECIFIED
BELOW. WHERE MORE THAN ONE MATERIAL IS LISTED FOR A PRODUCT,
SELECT PARAGRAPH FOR MATERIAL YOU WANT.
EDIT BRACKETED TEXT TO SPECIFY FINISH. DELETE TEXT NOT DESIRED.
MATERIALS & FINISHES NOT LISTED MAY BE AVAILABLE BY SPECIAL
ORDER.
DOOR BOTTOM: PEMKO No. 18062CP
HOUSING:
Aluminum, Extruded
* Alloy Type 6063-T5
* Chemical and physical properties per the Aluminum
Association, Inc.
* Federal Specification QQ-A-200/9C.
* [18062CP, Clear Anodized; 18062DP, Dark Bronze
Anodized; 18062GP, Gold Anodized]
BRUSH:
* Nylon, Type 6, heat stabilized
PERIMETER GASKETING: PEMKO No. 45062CP
HOUSING:
Aluminum, Extruded
* Alloy Type 6063-T5
* Chemical and physical properties per the Aluminum
Association, Inc.
* Federal Specification QQ-A-200/9C.
* [45062CP, Clear Anodized; 45062DP, Dark Bronze
Anodized; 45062GP, Gold Anodized]
BRUSH:
* Nylon, Type 6, heat stabilized.
4.TEST & CODE COMPLIANCE:
Fire Label: Classified By UL For Application To Swinging
Type Fire Doors of the Hollow Metal or Steel
Covered composite type Rated up to 3 Hours, or
Wood Core Fire Doors rated up to 1-1/2
Hours Listed and Labeled as Gasketing
Materials. Tested in accordance with UL10B
by Underwriters Laboratory, Inc. .
Smoke Label: Smoke tested by WYLE Laboratories in
accordance with UL 1784-90; meets the
requirements of NFPA 105.
5.INSTALLATION:
Installation to be performed in strict accordance with
manufacturers instructions furnished with product.
Door Bottom: Cut to length equal to door width,crimp
ends of brush backing to retain bristles. Fasten to
bottom of door, locate screws in center of slots.
Adjust for proper contact with floor and tighten screws.
Perimeter Gasketing:Trim to length, crimp ends of brush
backing to retain bristles. Fasten to header first, then
jambs, ensure contact at threshold, hold lightly against
door and install screws in center of slots (drill metal
frame 7/64" or #36) Carefully miter or cope at corners
to ensure tight joints and continuous seal. Adjust as
required and tighten screws.
6 WARRANTY:
Guaranteed by manufacturer against defects in material
or workmanship for three years