architecture - engineering - construction
Field Painting Tectum™ Panels with Sherwin Williams Paint
Other News Subscribe to FREE newsletter | Dec 11, 2009 |
Tectum Inc. and Sherwin Williams recommend the following specification for field painting of Tectum panels. With more than 2600 locations in the United States and Canada, Sherwin Williams has the correct "Waterborne Acrylic Dry Fall" paint for use on Tectum panels. Tests have shown that six coats of spray-applied paint have no effect on the acoustical properties of the Tectum panels. Sherwin Williams developed the following specification for field painting Tectum panels.
Tectum Panel Field Painting Specification | ||
Recommendation: | Sherwin Williams | |
Product: | Waterborne Acrylic Dry Fall (B42W1) 50 GAL. Drums | |
Recommended Spread Rate per Coat | ||
Wet Mils: | 3.5 - 5.0 | |
Dry Mils: | 1.5 - 2.0 | |
Coverage: | 336-450 sq. ft. / gallon approximate (based on flat surface) | |
* If necessary, cross spray at a right angle | ||
Surface Preparation | ||
Surface must be clean, dry, and in sound condition. Remove all oil, dirt, grease, and other foreign material to ensure adequate adhesion. | ||
Application Condition | ||
Temperature: | 50 deg. F minimum, 110 deg. F maximum (air, surface, and material) At least 5 deg. F above dew point Relative | |
Humidity: | 75% maximum | |
Dry Time: | 20 minutes | |
Recoat: | 1 hour | |
*During the early stages of drying, the coating is sensitive to rain, dew, high humidity, and moisture condensation. Plan painting schedules to avoid these influences during the first 16-24 hours of curing. Dryfall characteristics will be adversely affected at temperatures below 77 deg. F or above 50% relative humidity. | ||
Application Equipment | ||
The following is a guide. Changes in pressure and tip sizes may be needed for proper spray characteristics. | ||
Airless Spray: | Pressure | 2800 |
Hose | 1⁄4" ID | |
Tip | 0.013" | |
Reduction | As needed up to 10% by volume. | |
Conventional Spray: | Gun | Binks 95 |
Fluid Nozzle | 63C | |
Air Nozzle | 63PB | |
Atomization Pressure | 60 psi | |
Fluid Pressure | 50 psi | |
Reduction | As needed up to 20% by volume | |
Brush and Roller: | Not recommended | |
* Tectum Panels should be fastened in place priorto field painting. |
For other relevant searches, you might want to try:
(07 42 00) Wall Panels