architecture - engineering - construction
|
SafetyRail 2000 Rooftop Guardrail System
Other News
Subscribe to FREE newsletter
| Jun 30, 2016 |
THE FULLY OSHA-COMPLIANT PASSIVE FALL PROTECTION SYSTEM
The SafetyRail 2000 (SR2K) is a non-penetrating, passive fall protection system for workplace safety in rooftop or ground level applications. Used as a portable or permanent solution, the SafetyRail 2000 System’s unique design eliminates the cost and danger of potential trip hazards created by intermediate counterweights used in other guardrail systems. When the 108-pound cast iron bases are installed in a run with a 90-degree return on each end, the combined mass and the geometry of the installation creates an OSHA-compliant barrier for roof edge protection.
Features:
- No drilling required
- Portable or permanent guardrail
- Install over 250 feet in an hour with two workers
- Rails can be positioned in infinite directions
- Each base can support up to 4 rails
- Gate assemblies available
- Optional toe board brackets
- All rail sections are available in a powder-coated or galvanized finish
- Special orders for non-standard colors also available
- Custom engineering / manufacturing for special requirements
- Meets and exceeds OSHA regulations 29 CFR 1910.23 and 1926.500 – 1926.503
Applications:
- Fall Protection
- Temporary Fall Protection
- Roof Edge Protection
- Roof Hatches
- Skylights
- Hazard Barriers
- Warehouse Dock Doors
- Warehouse Traffic Lanes
- Cell Workstations
- Construction Dig Sites
- Dock Platforms
- New Building Construction
- Drive-In Truck Pits
- Rail Car Platforms
- Mezzanines
- Break Areas
- Assembly Areas
- Conveyors
For other relevant searches, you might want to try: